ASC MINX PORTABLE MIXER Carrying Case £200
ASC MINX PORTABLE MIXER Carrying Case As NEW (USED)
Normally £745 + £32 for carrying case - YOU GET IT FOR £200
Selling simply for financial reasons. Only used a few times (Mint condition)
A lightweight portable mono field mixer, suited for outside broadcast, public events, training and other similar applications. The Minx mixer incorporates communications and monitoring facilities only usually found on much larger and more expensive mixers and is used by leading broadcasters worldwide.
The MINX has three transformer-balanced XLR mic/line inputs front-panel high-pass filter, PFL button and dual-concentric gain and fader controls. A cue input is provided on balanced XLR and terminal posts. The main output is provided on both balanced XLR and terminal-posts (isolated from each other) and switchable 0dB/-50dB, so Minx mixers can be cascaded, feed a radiomic, or be used as a microphone sub-mixer.
There are two headphone outputs on jacks, with separate level controls, a high-quality PPM meter and LED overload indicator, linked to a switchable limiter. There is also a built-in talkback microphone, and talkback, presenter’s and engineer’s headphones can be switched separately to cue or output. A line-up oscillator is also provided and the mixer is powered from either mains or batteries, giving approximately 10 hours use.
Technical note:
Canford are brilliant at giving Technical Support on this and other audio items.
Technical Specification: Mic Line Output
Frequency response (±1dB): 40-15,000 Hz 40-15,000 Hz 40-15,000 Hz
Input sensitivity: –70 to -40dBu –20 to +10dBu
Headroom at inputs
(fader fully-open): 30dB 20dB
Noise
(A-weighted, referred to input): –124.7dB –82.3dB –78.1dB
Impedance: >1k ohm floating >10k ohm floating 75 ohm (XLR line)
200 ohm (XLR mic)
600ohm (terminals)
Dimensions (h x w x d): 66 x 223 x 193 mm
Weight: 1.85 kg
Minx Mixer Carrying Case with a full-width accessory pocket designed specifically to hold two Sennheiser, Micron or similar sized radiomic receivers (or a Micron with a battery pack), and full-width top and bottom flaps with hook and loop fastenings. The case has an adjustable strap for hand or shoulder carrying, and a non-slip shoulder pad.